Reference Guide

Property Description
LocalOnly
This property shows if the events from this the event source should be reported to the local
indication consumer only or should be reported to CIMOM as an indication. TRUE for
reporting to local consumer only, and FALSE for reporting as an indication.
MaxDisplayNotications
The maximum number of indications of this type that will be sent to the local display.
MaxNTEventLogNotications
The maximum number of indications of this type that will be sent to the local display.
Name
The label by which the Conguration object is known.
OtherAlertType
A string describing the Alert type - used when the Alert type property is set to 1, Other
State Change.
PollEnabled
This property shows if status-polling of the event source is enabled or not. TRUE for enable,
and FALSE for disabled.
PollingInterval
The polling interval for event source, in seconds.
ProbableCause
An enumerated value that describes the probable cause of the situation which resulted in
the AlertIndication.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Adapter/Card Error
• 3 = Application Subsystem Failure
• 4 = Bandwidth Reduced
• 5 = Connection Establishment Error
• 6 = Communications Protocol Error
• 7 = Communications Subsystem Failure
• 8 = Conguration/Customization Error
• 9 = Congestion
• 10 = Corrupt Data
• 11 = CPU Cycles Limit Exceeded
• 12 = Dataset/Modem Error
• 13 = Degraded Signal
• 14 = DTE-DCE Interface Error
• 15 = Enclosure Door Open
• 16 = Equipment Malfunction
• 17 = Excessive Vibration
• 18 = File Format Error
• 19 = Fire Detected
• 20 = Flood Detected
• 21 = Framing Error
• 22 = HVAC Problem
• 23 = Humidity Unacceptable
• 24 = I/O Device Error
• 25 = Input Device Error
• 26 = LAN Error
• 27 = Non-Toxic Leak Detected
• 28 = Local Node Transmission Error
• 29 = Loss of Frame
• 30 = Loss of Signal
• 31 = Material Supply Exhausted
202
Dell Command | Monitor10.1.0 classes and properties