Reference Guide

Property Description
• 11 = Reset
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
SensorType
The Type of the Sensor, e.g. Voltage or Temperature Sensor. If the type is set to Other, then
the OtherSensorType Description can be used to further identify the type, or if the Sensor
has numeric readings, then the type of the Sensor can be implicitly determined by the Units.
A description of the dierent Sensor types is as follows: A Temperature Sensor measures
the environmental temperature. Voltage and Current Sensors measure electrical voltage and
current readings. A Tachometer measures speed/revolutions of a Device. For example, a Fan
Device can have an associated Tachometer which measures its speed. A Counter is a
general purpose Sensor that measures some numerical property of a Device. A Counter
value can be cleared, but it never decreases. A Switch Sensor has states like Open/Close,
On/O, or Up/Down. A Lock has states of Locked/Unlocked. Humidity, Smoke Detection
and Air Flow Sensors measure the equivalent environmental characteristics. A Presence
Sensor detects the presence of a PhysicalElement. A Power Consumption Sensor measures
the instantaneous power consumed by a managed element. A Power Production Sensor
measures the instantaneous power produced by a managed element such as a power supply
or a voltage regulator. A pressure sensor is used to report pressure. Intrusion sensor reports
an intrusion of an enclosure regardless whether it was authorized or not.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Temperature
• 3 = Voltage
• 4 = Current
• 5 = Tachometer
• 6 = Counter
• 7 = Switch
• 8 = Lock
• 9 = Humidity
• 10 = Smoke Detection
• 11 = Presence
• 12 = Air Flow
• 13 = Power Consumption
• 14 = Power Production
• 15 = Pressure
• 16 = Intrusion
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change — Indicates that no transition is in progress.
Dell Command | Monitor10.1.0 classes and properties 133