Reference Guide

Property Description
NumberOfEnabledCores
Number of processor cores enabled for processor.
OperationalStatus
Indicates the current statuses of the element. Various operational statuses are dened.
Many of the enumeration's values are self-explanatory. However, a few are not and are
described here in more detail.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = OK
• 3 = Degraded
• 4 = Stressed — Indicates that the element is functioning, but needs attention. Examples
of Stressed states are overload, overheated, and so on.
• 5 = Predictive Failure — Indicates that an element is functioning nominally but predicting
a failure in the near future.
• 6 = Error
• 7 = Non-Recoverable Error
• 8 = Starting
• 9 = Stopping
• 10 = Stopped — Implies a clean and orderly stop.
• 11 = In Service — Describes an element being congured, maintained, cleaned, or
otherwise administered.
• 12 = No Contact — Indicates that the monitoring system has knowledge of this element,
but has never been able to establish communications with it.
• 13 = Lost Communication — Indicates that the ManagedSystem Element is known to
exist and has been contacted successfully in the past, but is currently unreachable.
• 14 = Aborted — Implies an abrupt stop where the state and conguration of the element
may need to be updated.
• 15 = Dormant — Indicates that the element is inactive or quiesced.
• 16 = Supporting Entity in Error — Indicates that this element may be OK but that
another element, on which it is dependent, is in error. An example is a network service or
endpoint that cannot function due to lower-layer networking problems.
• 17 = Completed — Indicates that the element has completed its operation. This value
should be combined with either OK, Error, or Degraded so that a client can tell if the
complete operation Completed with OK (passed), Completed with Error (failed), or
Completed with Degraded (the operation nished, but it did not complete OK or did not
report an error).
• 18 = Power Mode — Indicates that the element has additional power model information
contained in the Associated PowerManagementService association.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
OperationalStatus replaces the Status property on ManagedSystemElement to provide a
consistent approach to enumerations, to address implementation needs for an array
property, and to provide a migration path from today's environment to the future. This
change was not made earlier because it required the deprecated qualier. Due to the
widespread use of the existing Status property in management applications, it is strongly
recommended that providers or instrumentation provide both the Status and
OperationalStatus properties. Further, the rst value of OperationalStatus should contain
the primary status for the element. When instrumented, Status (because it is single-valued)
should also provide the primary status of the element.
PrimaryStatus
Provides a high level status value, intended to align with Red-Yellow-Green type
representation of status. It should be used in conjunction with DetailedStatus to provide high
level and detailed health status of the ManagedElement and its subcomponents.
Possible values are:
• 0 = Unknown — Indicates the implementation is in general capable of returning this
property, but is unable to do so at this time.
118 Dell Command | Monitor10.1.0 classes and properties