Install Guide

• Custom — Installs selected features of Dell Command | Monitor.
5 If you have selected Custom installation, in the custom setup screen, you can now select additional features that you want to install:
• Standards-based Instrumentation — The Standards-based Instrumentation provides instrumentation available in the root/DCIM/
sysman. This namespace complies with the DMTF DASH standards.
• Enable SNMP — Enable SNMP supports Simple Network Management Protocol for client systems.
• Specify the installation directory
6 Click Next.
The Ready to Install the Program screen is displayed. If the Setup Type is Custom, then the Custom Setup screen is displayed,
allowing you to select specic program features, and the directory in which you want to install Dell Command | Monitor. Click Next.
7 Click Install.
The installation starts. The time taken for the installation to complete depends on the options selected and the computer hardware.
8 In the InstallShield Wizard Completed, click Finish.
The Dell Command | Monitor screen is displayed.
9 Click Close to complete the installation and exit the installation screen.
Enabling SNMP in Dell Command | Monitor
Perform the following steps to enable SNMP:
1 Double-click Dell Command | Monitor Update Package that you have downloaded from dell.com/support.
The Welcome to the InstallShield Wizard for Dell Command | Monitor screen is displayed.
2 Double-click the Dell Command | Monitor Update Package.
The Welcome to the InstallShield Wizard for Dell Command | Monitor screen is displayed.
3 Click Yes.
The Update Package screen is displayed.
4 Click Install.
The Welcome to the InstallShield Wizard for Dell Command | Monitor screen is displayed.
5 Click Next.
6 Read the software license agreement, select I accept the terms in the license agreement, and then click Next.
7 In the Setup Type screen, click Custom, and then click Enable SNMP.
NOTE
: The Standard-based instrumentation is selected by default.
8 Click Next
9 Click Install.
NOTE
: To install Dell Command | Monitor with the SNMP option enabled, use the following CLI command: <DUPNAME> /
passthrough ADDLOCAL=Core,Hapi,EnableSNMP /qn.
Installing Dell Command | Monitor in CLI or silent
mode
You can perform a silent or CLI installation of Dell Command | Monitor using a DUP or MSI le.
Table 1. Commands for installation
Operation Command Example and Comments
Silent installation using
DUP
To install Dell Command | Monitor in silent mode using the default settings,
run the DUP le with the /S option. This will install Dell Command |
Monitor to the default directory and in the default supported operating
system language.
Only users with Administrator
privileges can install or uninstall Dell
Command | Monitor 9.x.
12 Installing Dell Command | Monitor10.1.0 on systems running Microsoft Windows