Install Guide

Installing Dell Command | Monitor10.1.0 on

systems running Microsoft Windows

You can install Dell Command | Monitor using one of the following methods:

• Using the Graphical User Interface, also known as the Dell Command | Monitor installation wizard

• Using Command Line Interface (CLI) for silent Installation

NOTE: The Dell Command | Monitor installation le is available as a Dell Update Package (DUP) at dell.com/support. For more

information, see Downloading Dell Command | Monitor.

NOTE: The Dell Command | Monitor installation le is available as a Dell Update Package (DUP) at dell.com/support.

NOTE: The installation les are dierent for Windows 32-bit and 64-bit operating systems.

GUI Installation You can install Dell Command | Monitor using a DUP, or MSI le extracted from the DUP. The Dell Command |

Monitor installation wizard allows you to install the default package or perform a custom installation of specic

components required for a particular environment.

Silent or CLI

Installation

You can install Dell Command | Monitor using a software distribution tool such as Microsoft System Center

Conguration Manager (SCCM), with no end-user interaction.

You can use the MSI le or DUP to deploy Dell Command | Monitor to client computers on a network by using a

In the default installation mode, Dell Command | Monitor installs the Microsoft Windows Management Instrumentation (WMI) provider, two

services, and a driver. WMI uses the Communication port (COM) as the communication interface with providers. The services installed

with Dell Command | Monitor provide access to the system for events and data retrieval. A driver is also installed with Dell Command |

Monitor for secure communication with the BIOS and other low-level system resources.

NOTE

: In the custom installation mode, Dell Command | Monitor installs a Management Information Base (MIB) and an agent if

the Simple Network Management Protocol (SNMP) option is selected.

NOTE: Dell Command | Monitor does not support any type of remote access. Remote access to Dell Command | Monitor is

achieved using the remote-access protocols supported by WMI or SNMP.

NOTE: Inpout driver is installed to enable the conguration of GPIO pins using Dell Command | Monitor on Dell Embedded Box

PC 3000/5000 devices.

Topics:

• Installing Dell Command | Monitor using Dell Update Package

• Installing Dell Command | Monitor using the MSI le

• Enabling SNMP in Dell Command | Monitor

• Installing Dell Command | Monitor in CLI or silent mode

Installing Dell Command | Monitor using Dell Update

Package

You can install Dell Command | Monitor locally using the DUP downloaded from dell.com/support.

10 Installing Dell Command | Monitor10.1.0 on systems running Microsoft Windows