Users Guide
Table Of Contents
- Dell Command | Integration Suite for System Center Version 5.0 User’s Guide
- Introduction
- Using Dell Command | Integration Suite for System Center
- The Dell Command | Intel vPro Out Of Band Application
- Software Prerequisites
- Configuring WinRM on Client Systems
- Launching The Dell Command | Intel vPro Out of Band Application
- Account Setup
- Client Discovery
- Settings
- Remote Provisioning
- USB Provisioning
- Indications
- Client Configuration
- Operations
- Generating Reports
- Task Queue
- Troubleshooting
- Related Reference
1. From the left-hand side of the Task Sequence Editor, under Deploy Operating System, click Apply Operating System
Image.
2. Choose from the following options:
● Apply operating system from a captured image
● Apply operating system from an original installation source
3. Click Browse and select the operating system image or package.
4. Under Select the location where you want to apply this operating system select the Destination and Drive Letter.
5. Click OK.
You have successfully applied an operating system image.
Apply Driver Packages
To apply driver packages:
1. From the left side of the Task Sequence Editor, under Deploy Operating System, click Apply Driver Package.
2. Browse and select the Dell Client Driver Packages. The list of driver packages available in the Dell Deployment Pack is
displayed.
3. Select a package for your Dell client system and click Apply.
You have successfully added drivers.
14 Using Dell Command | Integration Suite for System Center