Setup Guide

NOTE: Dell Command | Intel vPro Out of Band cannot be installed without also installing or having

previously installed Dell Command | Integration Suite for System Center 2012.

1. Go to dell.com/support/downloads.

2. Download and run the installer for Dell Command | Integration Suite for System Center 2012.

3. Follow the installer instructions, and select Complete Installation or Custom Installation based on

your requirements.

To prevent a specific feature from being installed, click the drop down box next to the feature, and

select This feature will not be available.

Using the Change or Repair Options in the Installer

The Modify or Change option on the Dell Command | Integration Suite for System Center 2012 installer

modifies the program features that are installed. This option enables you to perform the following

actions:

• Install a feature that you did not install earlier.

• Remove a feature that you installed earlier.

The repair option in the installer allows you to repair any installation errors that may have occurred during

installation.

1. Open Control Panel and click Programs and Features, and then click the Uninstall tab.

2. Click Dell Command | Integration Suite for System Center 2012, and then follow the uninstaller

instructions to uninstall, change, or repair your installation.

Upgrading Dell Command | Integration Suite for System

Center 2012

Upgrade to the current version of Dell Command | Integration Suite for System Center 2012 is not

supported for versions older than Dell Command | Integration Pack (DCIP) version 3.0. For more

information, see Installing Dell Command | Integration Suite for System Center 2012.

NOTE: During the upgrade, DCIP is uninstalled. If the upgrade process is interrupted, the DCIP

uninstall cannot be rolled back.

Uninstalling Dell Command | Integration Suite for System

Center 2012

NOTE: If you have set up subscriptions using Dell Command | Intel Out Of Band Plug-in,

uninstalling Dell Command | Integration Suite for System Center 2012 may leave clients subscribed

and producing indications that use unnecessary bandwidth. Ensure that you have unsubscribed all

clients prior to uninstalling Dell Command | Integration Suite for System Center 2012. See

Unsubscribing All Subscriptionsin your User Guide.

To uninstall Dell Command | Integration Suite for System Center 2012:

1. Close all running instances of Dell Command | Integration Suite for System Center 2012 and the

Configuration Manager console.

2. Open Control Panel, click Programs and Features.

3. Right-click Dell Command | Integration Suite for System Center 2012, and then click Uninstall.