Release Notes

Description: If any of the fans is not working, the advsm option displays the status as Other.
Issue: Advance Battery Charge and Peak Shift Charge options display Disable.
Description: Platforms that do not support Advance Battery Charge option, when advbatterychargecfg option is enumerated,
the system displays the option as Disable.
Platforms that do not support Peak Shift Charge option, when peakshiftcfg option is enumerated, the system displays the
option as Disable.
Issue: Temperature probe in Advanced System Management option displays as Unknown.
Description: On some platforms that support Advanced System Management option, temperature probe of all the sensors
displays as Unknown.
NOTE: This issue will be addressed in the upcoming BIOS versions.
Issue: On some of the platforms that support Advanced System Management option, temperature probe of Memory sensor 2
displays the current status as Non-Critical instead of Normal.
NOTE: This issue is addressed in the upcoming BIOS versions.
Issue: On some of the platforms that support Advanced System Management option, when you set non-critical upper threshold
values for cooling device, the CLI indicates that the action failed; however, setting the same is successful.
Issue: Windows Camera freezes for two milli seconds, while running the Dell Command | Configure SCE or importing .ini file.
Issue: A warning message is not displayed for BootOrder while enabling and disabling the same device.
Description: Dell Command Configure does not display any warning messages when you try to enable or disable the same
bootable device.
Example: cctk bootorder --bootlisttype=uefi --EnableDevice=hdd.1,hdd.2 --DisableDevice=hdd.1,hdd.2
Resolution: If the current status of the device is enabled, then the same device will be disabled or vice versa.
Issue: If Dell Command | Monitor 10.2 and Dell Command | Configure 4.1 (or any prior versions) are installed in a system, then
the Dell Command | Configure 4.1 (or any prior versions) may not work.
Issue: After the setup password has been set in XPS 9300, Precision 7700, and Precision 7500 series platforms, these
platforms does not allow you to set the system password.
Issue: If you run SCE in windows 7 operating system, Program Compatibility Assistant error is displayed periodically.
Resolution: On Program Compatibility Assistant window, click This program installed correctly and then continue with
the further steps.
Limitations
Not applicable.
Installation, Upgrade, and Uninstallation Instructions
For information on installation, uninstallation, and upgrade of Dell Command | Configure, see the Dell Command | Configure
Installation Guide at dell.com/dellclientcommandsuitemanuals.
Installation Prerequisites for Windows
● The Dell Command | Configure installation file, Dell-Command-Configure_<SWB>_WIN_4.2.1.<build
number>_A00.EXE available at dell.com/support.
● Workstation running a supported Microsoft Windows operating system.
● Administrator privileges on the system to install Dell Command | Configure .
● Microsoft .NET 4.0 to install and run the GUI.
NOTE:
Select Microsoft .NET Framework 4.0 or later on the Turn Windows features on or off screen on systems
running Windows 7 or later operating systems.
NOTE:
7