Release Notes

Fix: Issue in validating the feature for non enum types has been resolved.
Fix: Issues observed on the platforms where System and Setup Passwords are not supported has been resolved.
Fix: Dell Command | Configure SCE crashes once you enter " in any of the following fields: Passwords, Asset, or PropOwntag
issue has been resolved.
Fix: Dell Command | Configure crash issue on 19H1 Operating System has been resolved.
Fix: Import .ini displays an 146 error code with KeyboardBacklightColor feature on non supported system, this issue has been
resolved.
Fix: Removing HAPI install from WinPE scripts.
Fix: The set operation failure message for SHA256 BIOS feature has been resolved.
NOTE: No escape sequence is required in GUI for text field features.
Importance
RECOMMENDED: Dell recommends applying this update during your next scheduled update cycle. The update contains feature
enhancements or changes that will help keep your system software current and compatible with other system modules
(firmware, BIOS, drivers and software).
Known Issues: Command Line Interface
Issue: Unable to use Dell Command | Configure after reinstallation/upgrade.
Description: Dell command | Configure may not work after reinstallation/upgrade on Ubuntu Desktop 16.04 because dcdbus
module may not be loaded during reinstallation.
Resolution: Load the module by running the following command:
insmod <filename>
Issue: Windows 7 does not recognize the digital signature validity.
Description: If the system is not connected to internet, Windows 7 does not recognize the digital signature validity of Dell
Command | Configure installation file.
Resolution: Connect the system to internet and validate the digital signature.
Issue: Do not use the infile or outfile options in the .ini file.
Issue: Dell Command | Configure supports only single-byte characters for asset set operation.
Resolution: If the user has a different locale, change the keyboard layout to English before using the asset option.
Issue: TPM-related tokens can be modified independently.
Description: Dell Command | Configure does not control the dependencies among the various TPM PPI options. For example, it
is possible to change the TPM PPI ACPI option through Dell Command | Configure even when TPM is not On.
NOTE: There is no negative impact due to this on the BIOS.
Issue: Dependent options are not working as configured in UEFI mode for Legacy Option ROM and Secure Boot
Description:
● Dell Command | Configure allows enabling Legacy Option ROM when Secure Boot is On.
● Dell Command | Configure allows disabling Legacy Option ROM when Boot mode is Legacy.
● Dell Command | Configure allows enabling Secure Boot when Legacy option ROM is enabled and boot mode is UEFI.
● Dell Command | Configure does not allow enumerating Secure Boot when it is disabled.
NOTE: There is no negative impact due to this on the BIOS. This issue will be addressed in the upcoming BIOS versions.
Issue: Blinkpsu1led and Blinkpsu2led missing in the .ini file or SCE.
Description: Blinkpsu1led and Blinkpsu2led will not be present in the .ini file or SCE as they are enable-only tokens and they are
active only for few seconds. These tokens cannot be modified using GUI.
Issue: advsm option displays the status as Other
6