Reference Guide

Table 320. --PeakShiftBatteryThreshold (continued)
Attribute Details Description
Sets the value of Peak Shift battery threshold. When the Peak Shift battery threshold level is
reached, the system starts using AC power. Setting the value to 00 percent allows the system
to use power only from the battery during Peak Shift duration (Peak Shift Start time and Peak
shift End time).
Example
C:\>cctk --PeakShiftBatteryThreshold=50
PeakShiftBatteryThreshold=50
--PeakShiftCfg
Table 321. --PeakShiftCfg
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables Peak Shift battery configuration. Using Peak Shift configuration, you can
minimize the consumption of AC power during the peak power usage period of the day with
the enable and disable options. You can set a start and end time for the Peak Shift period.
During this period, the system runs on battery if the battery charge is above the set battery
threshold value. After the Peak Shift period, the system runs on AC power without charging
the battery. The system functions normally using AC power and recharging the battery after
the specified Charge Start Time.
NOTE: To use PeakShiftCfg, set the values of Operate only on battery,
Operate only on AC, and Resume normal power/charge. The values must be
set in such a way that Peak shift start time <= Peak shift end time <= Peak shift charge
start time.
NOTE: The value of hour must be in the range 00–23 and minute must be 00,15, 30, or 45.
To set 12 a.m., provide the hour value as 00.
Example
To enable Peak Shift battery configuration:
C:\>cctk --PeakShiftCfg=Enabled
PeakShiftCfg=Enabled
To enable Peak Shift battery configuration on specific days for a specific period:
C:\>cctk --
PeakShiftCfg=Enabled,mon-10:30/14:00/16:00,tue-10:30/14:00/16:30
To disable Peak Shift battery configuration:
C:\>cctk --PeakShiftCfg=Disabled
PeakShiftCfg=Disabled
--PenMisIndication
Table 322. --PenMisIndication
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the missing pen indication. This controls tablet PC pen removal. The pen
LED blinks to indicate that the pen has been removed from the retaining well.
94 Options for Dell Command | Configure 4.3