Reference Guide

Table 523. --WakeonLAN (continued)
Attribute Details Description
● LanWithPxeBoot — Enables the network controller and causes the system to wake up
and immediately boot to PXE when a wake packet is sent to the system in the S4 or S5
state.
● SfpNic — Allows the system to wake-up by special SFP signals.
● LanOrSfpNic — Allows the system to wake-up either by LAN, or by SFP signals.
● SfpNicWithPxeBoot — Allows the system to wake-up by SFP singnals, and immediately
boot to PXE.
Example
C:\>cctk --WakeOnLan=LanWithPxeBoot
WakeOnLan=LanWithPxeBoot
--WakeOnLan2
Table 524. --WakeOnLan2
Attribute Details Description
Valid Argument LanOnly, Disabled, LanWithPxeBoot
Defines the wake-on-LAN2 feature.
● LanOnly — The system wake-on-LAN feature is enabled; either an onboard or an add-in
NIC can wake the system up.
● Disabled — The system does not respond to magic packets or other means of wake-on-
LAN. The NIC chip section that looks for packets will not be powered.
● LanWithPxeBoot — Enables the network controller and causes the system to wake up
and immediately boot to PXE when a wake packet is sent to the system in the S4 or S5
state.
Example
C:\>cctk --WakeOnLan2=LanWithPxeBoot
WakeOnLan2=LanWithPxeBoot
--WakeOnLanBootOvrd
Table 525. --WakeOnLanBootOvrd
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the wake on LAN boot override feature.
● Enabled — When the system powers on due to a wake-on-LAN event, the NIC boot-ROM
is automatically given the highest boot priority, pre-pending the PXE boot-ROM to the
system current boot sequence. If the system powers on due to some other event, this
selection does not influence the boot sequence.
● Disabled — Disables the boot override feature and the system boot sequence is in effect
for all types of system power on.
--WarningsAndErr
Table 526. --WarningsAndErr
Attribute Details Description
Valid Argument PromptWrnErr, ContWrn, ContWrnErr
136 Options for Dell Command | Configure 4.3