Install Guide

ManualsBrandsDell ManualsAnalyticsCommand | Configure

Table Of Contents

Dell Command | Configure Version 4.3 Installation Guide
Introduction to Dell Command | Configure 4.3
Installing Dell Command | Configure 4.3 for systems running on Windows
Installing Dell Command | Configure 4.3 for systems running on Linux
Uninstalling Dell Command | Configure 4.3 for systems running on Windows
Uninstalling Dell Command | Configure 4.3 for systems running on Linux
Upgrading Dell Command | Configure 4.3 for systems running on Windows
- Upgrading Dell Command | Configure for systems running on Windows using a DUP
- Upgrading Dell Command | Configure for systems running on Windows using the MSI file
  - Upgrading in the default folder
  - Upgrading in a custom folder
Upgrading Dell Command | Configure 4.3 for systems running on Linux
Dell Command | Configure 4.3 for Windows Preinstallation Environment
- Creating a bootable image preinstallation environment using Windows PE 4.0, 5.0, and 10.0
- Creating a bootable image preinstallation environment using Windows PE 2.0 and 3.0
  - Integrating Dell Command | Configure directory structure into an ISO file using Windows PE 3.0
    - Creating a Windows PE 3.0 64-bit image
    - Creating a Windows PE 3.0 32-bit image
  - Integrating the Dell Command | Configure directory structure into a WIM file using Windows PE 2.0
    - Creating a bootable Windows PE image using Windows AIK
References for Dell Command | Configure 4.3
- Accessing documents from the Dell EMC support site

Uninstalling Dell Command | Configure for systems

running on Ubuntu Core 16

Run the following command to uninstall Dell Command | Configure from the systems running on Ubuntu Core 16:

snap remove dcc

Uninstalling Dell Command | Configure 4.3 for systems running on Linux 15