Reference Guide

Table 77. BootOrder (continued)
Attribute Details Description
● embnic—Embedded NIC
● fibrechannelex — FibreEx Channel
● infiniband—Infiniband Device
● vendor—Vendor Device
● i1394—I1394 Device
● i2o—I20 Device
● uart—UART Device
● lun—LUN Device
● vlan—VLAN Device
● nvme—NVMe Device
● uri—URI Device
● ufs—UFS Device
● sd—SD Device
● bluetooth—Bluetooth Device
● wifi—Wi-Fi Device
● emmc—eMMC Device
NOTE: For legacy boot list, unknown devices are displayed as hexadecimal values. For
UEFI boot list, some of the devices are displayed as UEFI with a <number> notation.
Change the bootorder by providing the short form of the unknown device.
NOTE: While changing the bootorder sequence, if the system is set with a setup
password, specify the setup password as the -- valsetuppwd argument. If the system has
a system password set and no setup password is set, specify the system password as the
-- valsyspwd argument.
Sub Options
The following are the sub options of bootorder.
--ActiveBootList
Table 78. --ActiveBootList
Attribute Details Description
Changes the active boot list in BIOS.
NOTE: If you set Legacy for the system that supports only UEFI, then the following error
message is displayed: Legacy option is not supported on this machine.
Example
C:\>cctk BootOrder --ActiveBootList=uefi
C:\>cctk BootOrder --ActiveBootList=legacy
--BootListType
Table 79. --BootListType
Attribute Details Description
Identifies which boot list type to display or modify for supported UEFI systems.
Options for Dell Command | Configure 4.x 41