Reference Guide

Table 569. Completion codes
Code Description
0000h The update was completed successfully.
0001h The image failed one or more consistency checks.
0002h The BIOS could not access the flash-memory device.
0003h The flash-memory device was not ready when an erase was attempted.
0004h Flash programming is currently disabled on the system, or the voltage is low.
0005h A battery must be installed for the operation to complete.
0006h A fully-charged battery must be present for the operation to complete.
0007h An external power adapter must be connected for the operation to complete.
0008h The 12V required to program the flash-memory could not be set.
0009h The 12V required to program the flash-memory could not be removed.
000Ah A flash-memory failure occurred during a block-erase operation.
000Bh A general failure occurred during the flash programming.
000Ch A data miscompare error occurred during the flash programming.
000Dh The image could not be found in memory or the header could not be located.
000Eh Reserved for future assignment via this specification.
FFFFh No update operation has been performed on the system.
Options for Dell Command | Configure 4.x 151