Reference Guide

--Serial6
Table 392. --Serial6
Attribute Details Description
Valid Argument Disabled, Auto
Configures the 6th serial port of the system.
--SerialComm
Table 393. --SerialComm
Attribute Details Description
Valid Argument Off, On, Com1Cr, Com2Cr
Sets the behavior of the serial port communication.
● Off—Disables the COM port 1 and COM port 2.
● On—Enables the COM port 1 and COM port 2. These ports are made available for use by
the operating system or applications. BIOS Console Redirection is disabled.
● Com1Cr—Enables the COM port 1 and COM port 2. These ports are made available for use
by the operating system or applications. BIOS Console Redirection is through COM port 1.
● Com2Cr—Enables the COM port 1 and COM port 2. These ports are made available for
use by the operating system or applications. BIOS Console Redirection is through COM port
2.
--Serr
Table 394. --Serr
Attribute Details Description
Valid Argument Enabled, Disabled
Turns the serr Dmi messages on or off.
--SetupPwd
Table 395. --SetupPwd
Attribute Details Description
Valid Argument <password>
Sets the setup password. An argument is required. The password cannot be displayed. Initially
you can set the password. If you want to remove the password, provide one blank space and
the old password.
Example
NOTE: Password containing special characters must be provided in double inverted
commas (“”).
To set the password:
C:\>cctk --SetupPwd=<new-password>
To change the password:
C:\>cctk --SetupPwd=<old-password> --ValSetupPwd=<new-password>
Options for Dell Command | Configure 4.x 109