Reference Guide

Table 348. --PpiBypassSedBlockSidCommand (continued)
Attribute Details Description
When there is no drive ownership and the PpiBypassSedBlockSidCommand is enabled, the
BIOS requires user input while sending the Block SID authentication command to SED drives.
When PpiBypassSedBlockSidCommand is disabled, the BIOS does not require user input while
sending the Block SID command.
NOTE: You can enable PpibypassSedBlockSidCommand in manufacturing mode or while
setting up the BIOS Setup Administrator password.
NOTE: The read-only mechanism can be changed when the system is in manufacturing
mode, while the PpiBypassSedBlockSidCommand is enabled.
--PrimaryBattChargeCfg
Table 349. --PrimaryBattChargeCfg
Attribute Details Description
Valid Argument Standard, Express, PrimAcUse, Adaptive, Custom
Configures the primary battery charging.
● Standard—Charges the battery over a longer period of time.
● Express—Charges the battery using the express charging algorithm, Dell's fast charging
technology.
● PrimAcUse—Charges battery while plugged-in.
● Adaptive—Charges the battery based on a periodic evaluation of battery usage to deliver
the best balance capacity.
● Custom—The battery charging starts and stops based on user input. The start value range
should be 50-95 percent, the stop value range should be 55-100 percent, and the
difference between the start and stop values should be greater than or equal to 5.
Example
C:\>cctk --PrimaryBattChargeCfg=Standard
PrimaryBattChargeCfg=Standard
C:\>cctk --PrimaryBattChargeCfg=Custom:50-70
PrimaryBattChargeCfg=Custom:50-70
NOTE: The format to set custom option is custom:start value-stop value. The
start value range must be 50–95 percentage and the stop value range must be 55–100
percentage. The difference between the start and stop values must be greater than or
equal to 5.
--PrimaryVideoSlot
Table 350. --PrimaryVideoSlot
Attribute Details Description
Valid Argument Auto, Slot0, Slot1, Slot2, Slot3, Slot4, Slot5, Slot6, Slot7, Slot8, Slot9, Slot10, Slot11, Slot12,
Slot13, Slot14, Slot15Onboard
Configuring the slot for Primary video display.
● Onboard—Sets the onboard video device slot as primary video device slot.
● Auto—Scans PCI buses and uses the first video device slot found with video card as a
primary video device slot.
● Slot0-Slot15—Sets the specified slot number as a primary video device slot.
100 Options for Dell Command | Configure 4.x