Reference Guide

Table 334. --PciSlots (continued)
Attribute Details Description
Enables or disables the add-in PCI slots of the system.
--Pcmcia
Table 335. --Pcmcia
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the PCMCIA device slot.
--PeakShiftBatteryThreshold
Table 336. --PeakShiftBatteryThreshold
Attribute Details Description
Valid Argument integers ranging from 15 to 100
Sets the value of Peak Shift battery threshold. When the Peak Shift battery
threshold level is reached, the system starts using AC power. Setting the value to
00 percent allows the system to use power only from the battery during Peak Shift
duration (Peak Shift Start time and Peak shift End time).
Example
C:\>cctk --PeakShiftBatteryThreshold=50
PeakShiftBatteryThreshold=50
--PeakShiftCfg
Table 337. --PeakShiftCfg
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables Peak Shift battery configuration. Using Peak Shift configuration, you
can minimize the consumption of AC power during the peak power usage period of the
day with the enable and disable options. You can set a start and end time for the Peak
Shift period. During this period, the system runs on battery if the battery charge is above
the set battery threshold value. After the Peak Shift period, the system runs on AC
power without charging the battery. The system functions normally using AC power and
recharging the battery after the specified Charge Start Time.
NOTE: To use PeakShiftCfg, set the values of Operate only on battery,
Operate only on AC, and Resume normal power/charge. The values must
be set in such a way that Peak shift start time <= Peak shift end time <= Peak shift
charge start time.
NOTE: The value of hour must be in the range 00–23 and minute must be 00,15, 30,
or 45. To set 12 a.m., provide the hour value as 00.
Example
● To enable Peak Shift battery configuration:
C:\>cctk --PeakShiftCfg=Enabled
PeakShiftCfg=Enabled
Options for Dell Command | Configure 4.x 97