Reference Guide

Table 92. --CamVisionSen (continued)
Attribute Details Description
Setting this attribute to Enabled sets the SafeShutter BIOS option to Manual mode and
hides the setup option. SafeShutter is not applicable when this attribute is enabled.
--Camera2
Table 93. --Camera2
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the camera available at the back of the system.
● Enabled—Enables the camera available at the back of the system.
● Disabled—Disables the camera available at the back of the system.
--CanBus
Table 94. --CanBus
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the Controller Area Network (CAN) Bus.
--ChasIntrusion
Table 95. --ChasIntrusion
Attribute Details Description
Valid Argument Enabled, Disabled, SilentEnable
Enables or disables the system to detect and report chassis intrusion events to the
system display on boot-up.
--ChassisIntruStatus
Table 96. --ChassisIntruStatus
Attribute Details Description
Valid Argument DoorOpen, Tripped, DoorClosed, TripReset
Displays the status of chassis intrusion. All the values are read-only except tripreset.
● DoorOpen—Indicates chassis door is opened.
● Tripped—Indicates the chassis door is opened since the last time the sensor
detection logic was reset.
● DoorClosed—Indicates chassis door is closed.
● TripReset—Resets the sensor detection logic to detect the next closed-to-open
transition on the chassis door.
Options for Dell Command | Configure 4.x 47