Reference Guide

--WakeOnAc
Table 552. --WakeOnAc
Attribute Details Description
Valid Argument Enabled, Disabled
Sets the behavior of the system after AC power is lost.
● Enabled—When AC power is restored, the system turns on.
● Disabled—When AC power is restored, the system remains turned off.
--WakeOnDock
Table 553. --WakeOnDock
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables waking the system when a docking connection is made.
--WakeonLAN
Table 554. --WakeonLAN
Attribute Details Description
Valid Argument LanOnly, Disabled, AddInCard, OnBoard, WlanOnly, LanWlan, LanWithPxeBoot, Sfp, LanSfp,
SfpWithPxeBoot
Defines the wake-on-LAN feature.
● LanOnly—The system wake-on-LAN feature is enabled. Either an onboard or an add-in
NIC can wake the system up.
● Disabled—The system does not respond to magic packets or other means of wake-on-
LAN. The NIC chip section that looks for packets will not be powered.
● AddInCard—Enables NICs, plugged into the special power connector, as the source of any
wake-on-LAN signal.
● OnBoard —The onboard NIC is enabled for wake-on-LAN.
● WlanOnly—Enables wake-on-LAN for wireless.
● LanWlan—On systems that have onboard LAN and wireless LAN hardware, enables wake
on either wired or wireless LAN.
● LanWithPxeBoot—Enables the network controller and causes the system to wake up and
immediately boot to PXE when a wake packet is sent to the system in the S4 or S5 state.
● SfpNic—Allows the system to wake-up by special SFP signals.
● LanOrSfpNic—Allows the system to wake-up either by LAN, or by SFP signals.
● SfpNicWithPxeBoot—Allows the system to wake-up by SFP singnals, and immediately
boot to PXE.
Example
C:\>cctk --WakeOnLan=LanWithPxeBoot
WakeOnLan=LanWithPxeBoot
--WakeOnLan2
Table 555. --WakeOnLan2
Attribute Details Description
Valid Argument LanOnly, Disabled, LanWithPxeBoot
Options for Dell Command | Configure 4.x 141