Reference Guide

--ValHddPwd
Table 535. --ValHddPwd
Attribute Details Description
Valid Argument <password>
Sets the hard disk drive password. The password cannot be reported. To set the password an
argument is required. To remove the password, provide one blank space and the old password.
NOTE: Reboot the system to complete any HDD password actions.
--ValOwnerPwd
Table 536. --ValOwnerPwd
Attribute Details Description
Valid Argument <password>
--ValSetupPwd
Table 537. --ValSetupPwd
Attribute Details Description
Valid Argument <password>
This value must be provided when the system supports setup password.
--ValSysPwd
Table 538. --ValSysPwd
Attribute Details Description
Valid Argument <password>
This value is provided when the system supports only the system password and not the setup
password. Example: cctk BootOrder --EnableDevice=3,2 --ValSysPwd=syspassword
--VaPhysicalPresenceConfirm
Table 539. --VaPhysicalPresenceConfirm
Attribute Details Description
Valid Argument Enabled, Disabled
Sets the VA Physical Presence Confirmation. If set to off, it will allow VA install application to
make virtual appliance configuration changes without rebooting. If set to on, it forces VA install
application to reboot the system to make virtual appliance configuration.
--VgaDacSnoop
Table 540. --VgaDacSnoop
Attribute Details Description
Valid Argument Enabled, Disabled
138 Options for Dell Command | Configure 4.x