Reference Guide

--Serr
Table 405. --Serr
Attribute Details Description
Valid Argument Enabled, Disabled
Turns the serr Dmi messages on or off.
--SetupPwd
Table 406. --SetupPwd
Attribute Details Description
Valid Argument <password>
Sets the setup password. An argument is required. The password cannot be displayed.
Initially you can set the password. If you want to remove the password, provide one blank
space and the old password.
Example
NOTE: Password containing special characters must be provided in double inverted
commas (“”).
● To set the password:
C:\>cctk --SetupPwd=<new-password>
● To change the password:
C:\>cctk --SetupPwd=<old-password> --ValSetupPwd=<new-
password>
●
To remove the password:
C:\>cctk --SetupPwd= --ValSetupPwd=<old-password>
--SfpNic
Table 407. --SfpNic
Attribute Details Description
Valid Argument Enabled, Disabled, EnabledPxe
Enables or disables SfpNic (Small Formfactor Pluggable) device.
● Enabled—Enables the SFP device.
● Disabled—Disables the SFP device.
● EnabledPxe—Enables the SFP device with PXE support.
NOTE: SfpNic device is listed as boot device only if this attribute is enabled with PXE.
--SfuEnabled
Table 408. --SfuEnabled
Attribute Details Description
Valid Argument Yes, No
112 Options for Dell Command | Configure 4.x