Install Guide

ManualsBrandsDell ManualsAnalyticsCommand | Configure

Table Of Contents

Dell Command | Configure Version 4.5 Installation Guide
Contents
Introduction to Dell Command | Configure 4.5
Installing Dell Command | Configure 4.5 for systems running on Windows
Installing Dell Command | Configure 4.5 for systems running on Linux
Uninstalling Dell Command | Configure 4.5 for systems running on Windows
Uninstalling Dell Command | Configure 4.5 for systems running on Linux
Upgrading Dell Command | Configure 4.5 for systems running on Windows
- Upgrading Dell Command | Configure for systems running on Windows using a DUP
- Upgrading Dell Command | Configure for systems running on Windows using the MSI file
  - Upgrading in the default folder
  - Upgrading in a custom folder
Upgrading Dell Command | Configure 4.5 for systems running on Linux
Dell Command | Configure 4.5 for Windows Preinstallation Environment
- Creating a bootable image preinstallation environment using Windows PE 4.0, 5.0, and 10.0
- Creating a bootable image preinstallation environment using Windows PE 2.0 and 3.0
  - Integrating Dell Command | Configure directory structure into an ISO file using Windows PE 3.0
    - Creating a Windows PE 3.0 64-bit image
    - Creating a Windows PE 3.0 32-bit image
  - Integrating the Dell Command | Configure directory structure into a WIM file using Windows PE 2.0
    - Creating a bootable Windows PE image using Windows AIK
References for Dell Command | Configure
- Accessing documents from the Dell support site

Upgrading Dell Command | Configure 4.2 using Snap

package

To install Dell Command | Configure from a local directory,

1. Log in to the Gateway system.

Default username/password: admin/admin

2. Run the following command:

snap update dcc

Upgrading Dell Command | Configure 4.5 for systems running on Linux 19