Reference Guide

Table 12. --Absolute (continued)
Attribute Details Description
Sets the value to the Absolute interface and control the Absolute service using the following
options:
● Enabled - If enabled, then the Absolute service is activated or deactivated.
● Disabled - If disabled, then the Absolute service does not run.
● PermanentlyDisabled - If the Absolute interface is permanently disabled, then the
Absolute feature can be enabled by using the factory reset feature.
--AcPwrRcvry
Table 13. --AcPwrRcvry
Attribute Details Description
Valid Argument
off, last, on
Sets the behavior of the system after Alternating Current (AC) power is lost.
● Off — When AC power is restored, the system remains turned off.
● On — When AC power is restored, the system turns on.
● Last — When the AC power is restored, the system returns to the state it was in when the
power was lost.
--ActivityLed
Table 14. --ActivityLed
Attribute Details Description
Valid Argument
ActLed, Wlan, Disabled
Sets the Network Activity Light Emitting Diode (LED) to any of the following:
● ActLed — Sets the Activity LED controlled by an Advanced Configuration and Power
Interface (ACPI) operating system and driver.
● Wlan — Sets the Activity LED as a wireless Local Area Network (LAN) radio on/off
indicator.
● Disabled — Sets the Activity LED to off.
--AddDevice
Table 15. --AddDevice
Attribute Details Description
Valid Argument Usb
Adds the specified device to the boot device list. At present, only the Universal Serial Bus
(USB) storage device is supported. This option is not valid on all the systems. The USB storage
device is added at the end of the boot order. If the USB storage device is already added in the
boot order list, the following message is displayed while executing the option:USB device
is already present in this machine.
NOTE: The AddDevice option is not supported on the systems with UEFI-based BIOS.
Example
C:\>cctk --AddDevice=Usb
Options for Dell Command | Configure 4.2 25