Reference Guide

--SetupPwd
Table 368. --SetupPwd
Attribute Details Description
Valid Argument <password>
Sets the setup password. An argument is required. The password cannot be displayed. Initially
you can set the password. If you want to remove the password, provide one blank space and
the old password.
Example
NOTE: Password containing special characters must be provided in double inverted
commas (“”).
To set the password:
C:\>cctk --SetupPwd=<new-password>
To change the password:
C:\>cctk --SetupPwd=<old-password> --ValSetupPwd=<new-password>
To remove the password:
C:\>cctk --SetupPwd= --ValSetupPwd=<old-password>
--SfpNic
Table 369. --SfpNic
Attribute Details Description
Valid Argument Enabled, Disabled, EnabledPxe
Enables or disables SfpNic (Small Formfactor Pluggable) device.
● Enabled — Enables the SFP device.
● Disabled — Disables the SFP device.
● EnabledPxe — Enables the SFP device with PXE support.
NOTE: SfpNic device is listed as boot device only if this attribute is enabled with PXE.
--SfuEnabled
Table 370. --SfuEnabled
Attribute Details Description
Valid Argument Yes, No
Enables the verification of digital signatures in the BIOS update payload prior to the update. If
yes, the system BIOS can be updated to versions that have valid digital signatures. However, it
is not possible to restore the value.
--SgxLaunchControl
Table 371. --SgxLaunchControl
Attribute Details Description
Valid Argument IntelLocked, RuntimeSelectable
104 Options for Dell Command | Configure 4.2