Install Guide
Table Of Contents
- Dell Command | Configure Version 4.2 Installation Guide
- Introduction to Dell Command | Configure 4.2
- Installing Dell Command | Configure 4.2 for systems running on Microsoft Windows
- Installing Dell Command | Configure 4.2 for systems running on Linux
- Uninstalling Dell Command | Configure 4.2 for systems running on Microsoft Windows
- Uninstalling Dell Command | Configure 4.2 for systems running on Linux
- Upgrading Dell Command | Configure 4.2 for systems running on Microsoft Windows
- Upgrading Dell Command | Configure 4.2 for systems running on Linux
- Dell Command | Configure 4.2 for Microsoft Windows Preinstallation Environment
- Creating a bootable image preinstallation environment using Microsoft Windows PE 4.0, 5.0, and 10.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Microsoft Windows PE 10.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Microsoft Windows PE 5.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Microsoft Windows PE 4.0
- Creating a bootable image preinstallation environment using Microsoft Windows PE 2.0 and 3.0
- Creating a bootable image preinstallation environment using Microsoft Windows PE 4.0, 5.0, and 10.0
- References for Dell Command | Configure 4.2
3. Rename the <path_of_wim_file>\winpe.wim file as boot.wim.
4. Overwrite the <path_of_wim_file>\ISO\sources\boot.wim file with the <path_of_wim_file>\boot.wim file.
For example, copy C:\winPE_x86\boot.wim C:\winPE_x86\ISO\sources\boot.wim.
5. Create a bootable Windows PE image using Windows AIK.
Related Link:
● Creating a bootable Microsoft Windows PE image using Microsoft Windows AIK
Creating a bootable Microsoft Windows PE image using Microsoft Windows
AIK
1. Click Start > Programs > Microsoft Windows AIK > Windows PE Tools Command Prompt.
NOTE: To prepare a bootable image for a 64-bit supported system, from the command prompt, browse to the following
directory:
● For 64-bit system; <AIK_installation_directory>\Windows AIK\Tools\amd64
● For 32-bit system; <AIK_installation_directory>\Windows AIK\Tools\i86
Otherwise, <AIK_installation_directory>\Windows AIK\Tools\PEtools.
2. Run the command: oscdimg –n —b<path_of_wim_file>\etfsboot.com <path_of_wim_file>\ISO
<path_of_wim_file\image_file_name.iso>.
For example, oscdimg –n –bc:\winPE_x86\etfsboot.com c:\winPE_x86\ISO
c:\winPE_x86\WinPE2.0.iso.
This command creates a bootable ISO image, WinPE2.0.iso, in the path C:\winPE_x86 directory.
24
Dell Command | Configure 4.2 for Microsoft Windows Preinstallation Environment