Reference Guide

--LimitCpuidValue
Table 247. --KbdBacklightTimeoutAc
Attribute Details Description
Valid Argument Enabled, Disabled
Limits the maximum value the processor standard CPUID function supports. Some operating system
will be unable to install if the maximum CPUID function supported is greater than 3. If set to on, the
CPUID function is limited to 3. If set to off, the CPUID function is not limited to 3.
--LiquidCooler2
Table 248. --LiquidCooler2
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the liquid cooler 2.
• Enabled — Enables the liquid cooler 2.
• Disabled — Disables the liquid cooler 2.
--LiquidCooler1
Table 249. --LiquidCooler1
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the liquid cooler 1.
• Enabled — Enables the liquid cooler 1.
• Disabled — Disables the liquid cooler 1.
--LogicProc
Table 250. --LogicProc
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables hyper threading on the next system boot. On some Dell platforms that support
multi-core processor technology, this is enabled or disabled though the platform does not support
hyper threading. In this case, this command may enable or disable multi-core processor technology.
--Lpt
Table 251. --Lpt
Attribute Details Description
Valid Argument Lpt1, Lpt2, Lpt3
Defines the parallel port configuration. Lpt1 enables the built-in parallel port of the system to operate in
Lpt1 mode, using Input/Output (I/O) address 378. Lpt2 enables the system’s built-in parallel port to
operate in Lpt2 mode, using I/O address 278. Lpt3 enables the built-in parallel port to operate in Lpt3
mode, using I/O address 3BC.
Options for Dell Command | Configure 4.3 77