Reference Guide

--ActivityLed
Table 14. --ActivityLed
Attribute Details Description
Valid Argument
ActLed, Wlan, Disabled
Sets the Network Activity Light Emitting Diode (LED) to any of the following:
• ActLed — Sets the Activity LED controlled by an Advanced Configuration and Power Interface
(ACPI) operating system and driver.
• Wlan — Sets the Activity LED as a wireless Local Area Network (LAN) radio on/off indicator.
• Disabled — Sets the Activity LED to off.
--AdaptiveCStates
Table 15. --AdaptiveCStates
Attribute Details Description
Valid Argument Enabled, Disabled
Adaptive C-States allow the system to dynamically detect high usage of a discrete graphic and adjust
system parameters for higher performance during that time period.
This feature requires an AC adapter due to higher energy consumption, and dynamically it is not
possible to activate higher performance without an appropriate AC adapter. Other settings that
conserve power may block the utilization of this feature.
--AddDevice
Table 16. --AddDevice
Attribute Details Description
Valid Argument Usb
Adds the specified device to the boot device list. At present, only the Universal Serial Bus (USB)
storage device is supported. This option is not valid on all the systems. The USB storage device is
added at the end of the boot order. If the USB storage device is already added in the boot order list,
the following message is displayed while executing the option:USB device is already
present in this machine.
NOTE: The AddDevice option is not supported on the systems with UEFI-based BIOS.
Example
C:\>cctk --AddDevice=Usb
--AdiModeChannel1
Table 17. --AdiModeChannel1
Attribute Details Description
Valid Argument Unused, AdcInput, DacOutput, DacAndAdc, Gpio
Sets the defined Analog/Digital Interface mode for channel 1.
• Unused - Channel is unused.
• AdcInput - Sets the channel mode as Analog-to-Digital Converter (ADC) input.
Options for Dell Command | Configure 4.3 25