Reference Guide

For example, to set the non-critical threshold values for a current probe on a system with a system password and no setup password,
type:
cctk Advsm --Set=Current_1:10 --ValSysPwd = <system password>
For example, to set the non-critical threshold values for a cooling probe on a system with a system password and no setup password,
type:
cctk Advsm --Set=Cd_1:10 --ValSysPwd = <system password>
For example, to set the non-critical threshold values for a temperature probe on a system with a system password and no setup
password, type:
cctk Advsm --Set=Temperature_1:10 --ValSysPwd = <system password>
PCI reporting
The scan of the PCI bus will use a file to resolve PCI vendor and device codes to vendor information strings. The format of the PCI output
is as follows:
PCI Bus: 2, Device: 4, Function: 0
Vendor: 8086 - Intel Corp.
Device: 1229 - 82557/8/9 [Ethernet Pro 100]
Sub Vendor:8086 - Intel Corp.
Sub Device:1017 - EtherExpress PRO/100+ Dual Port Server Adapter
Slot: 01
Class: 02 - Network
SubClass: 00 - Ethernet
If the file for vendor resolution is not present, the utility will print Unknown next to a vendor name. If the file for environment variable
names is not present, the utility will fail the environment variable operation.
The pci.ids file is located at :
• Systems running on supported Windows operating system:
• For 32-bit systems; C:\Program Files\Dell\Command Configure\X86
• For 64-bit systems; C:\Program Files\Dell\Command Configure\X86_64
• Systems running on supported Linux operating system: /opt/dell/dcc
Completion code
The following table displays the completion code of an update operation performed by BIOS in the recent shutdown or reboot operation.
Table 552. Completion codes
Code Description
0000h The update was completed successfully.
0001h The image failed one or more consistency checks.
0002h The BIOS could not access the flash-memory device.
0003h The flash-memory device was not ready when an erase was attempted.
0004h Flash programming is currently disabled on the system, or the voltage is low.
0005h A battery must be installed for the operation to complete.
0006h A fully-charged battery must be present for the operation to complete.
0007h An external power adapter must be connected for the operation to complete.
0008h The 12V required to program the flash-memory could not be set.
0009h The 12V required to program the flash-memory could not be removed.
000Ah A flash-memory failure occurred during a block-erase operation.
Options for Dell Command | Configure 4.3 141