Release Notes

Description: On some platforms that support Advanced System Management option, temperature probe of all the sensors displays as

Unknown.

NOTE: This issue will be addressed in the upcoming BIOS versions.

Issue: On some of the platforms that support Advanced System Management option, temperature probe of Memory sensor 2 displays the

current status as Non-Critical instead of Normal.

NOTE: This issue is addressed in the upcoming BIOS versions.

Issue: On some of the platforms that support Advanced System Management option, when you set non-critical upper threshold values for

cooling device, the CLI indicates that the action failed; however, setting the same is successful.

Issue: Windows Camera freezes for two milli seconds, while running the Dell Command | Congure SCE or importing .ini le.

Issue: A warning message is not displayed for BootOrder while enabling and disabling the same device.

Description: Dell Command Congure does not display any warning messages when you try to enable or disable the same bootable device.

Example: cctk bootorder --bootlisttype=ue --EnableDevice=hdd.1,hdd.2 --DisableDevice=hdd.1,hdd.2

Resolution: If the current status of the device is enabled, then the same device will be disabled or vice versa.

Issue: If Dell Command | Monitor 10.2 and Dell Command | Congure 4.1 (or any prior versions) are installed in a system, then the Dell

Command | Congure 4.1 (or any prior versions) may not work.

Issue: After the setup password has been set in XPS 9300, Precision 7700, and Precision 7500 series platforms, these platforms does not

allow you to set the system password.

Issue: If you run SCE in windows 7 operating system, Program Compatibility Assistant error is displayed periodically.

Resolution: On Program Compatibility Assistant window, click This program installed correctly and then continue with the further steps.

Known Issues: Command Line Interface