Release Notes

Known Issues: Command Line Interface
Issue: Unable to use Dell Command | Congure after reinstallation/upgrade.
Description: Dell command | Congure may not work after reinstallation/upgrade on Ubuntu Desktop 16.04 because dcdbus module may
not be loaded during reinstallation.
Resolution: Load the module by running the following command:
insmod <filename>
Issue: Windows 7 does not recognize the digital signature validity.
Description: If the system is not connected to internet, Windows 7 does not recognize the digital signature validity of Dell Command |
Congure installation le.
Resolution: Connect the system to internet and validate the digital signature.
Issue: Do not use the inle or outle options in the .ini le.
Issue: Dell Command | Congure supports only single-byte characters for asset set operation.
Resolution: If the user has a dierent locale, change the keyboard layout to English before using the asset option.
Issue: TPM-related tokens can be modied independently.
Description: Dell Command | Congure does not control the dependencies among the various TPM PPI options. For example, it is possible
to change the TPM PPI ACPI option through Dell Command | Congure even when TPM is not On.
NOTE
: There is no negative impact due to this on the BIOS.
Issue: Dependent options are not working as congured in UEFI mode for Legacy Option ROM and Secure Boot
Description:
• Dell Command | Congure allows enabling Legacy Option ROM when Secure Boot is On.
• Dell Command | Congure allows disabling Legacy Option ROM when Boot mode is Legacy.
• Dell Command | Congure allows enabling Secure Boot when Legacy option ROM is enabled and boot mode is UEFI.
• Dell Command | Congure does not allow enumerating Secure Boot when it is disabled.
NOTE
: There is no negative impact due to this on the BIOS. This issue will be addressed in the upcoming BIOS versions.
Issue: Blinkpsu1led and Blinkpsu2led missing in the .ini le or SCE.
Description: Blinkpsu1led and Blinkpsu2led will not be present in the .ini le or SCE as they are enable-only tokens and they are active only
for few seconds. These tokens cannot be modied using GUI.
Issue: advsm option displays the status as Other
Description: If any of the fans is not working, the advsm option displays the status as Other.
Issue: Advance Battery Charge and Peak Shift Charge options display Disable.
Description: Platforms that do not support Advance Battery Charge option, when advbatterychargecfg option is enumerated, the system
displays the option as Disable.
Platforms that do not support Peak Shift Charge option, when peakshiftcfg option is enumerated, the system displays the option as
Disable.
Issue: Temperature probe in Advanced System Management option displays as Unknown.
10
Known Issues: Command Line Interface