Reference Guide

Attribute Details Description
• LanWithPxeBoot — Enables the network controller and causes the system to wake up and
immediately boot to PXE when a wake packet is sent to the system in the S4 or S5 state.
Example
C:\>cctk --WakeOnLan2=LanWithPxeBoot
WakeOnLan2=LanWithPxeBoot
--WakeOnLanBootOvrd
Table 506. --WakeOnLanBootOvrd
Attribute Details Description
Valid Argument Enabled, Disabled
Enables or disables the wake on LAN boot override feature.
• Enabled — When the system powers on due to a wake-on-LAN event, the NIC boot-ROM is
automatically given the highest boot priority, pre-pending the PXE boot-ROM to the system current
boot sequence. If the system powers on due to some other event, this selection does not inuence
the boot sequence.
• Disabled — Disables the boot override feature and the system boot sequence is in eect for all
types of system power on.
--WarningsAndErr
Table 507. --WarningsAndErr
Attribute Details Description
Valid Argument PromptWrnErr, ContWrn, ContWrnErr
During POST the system continues to boot or pauses when warnings or errors are detected. This
feature can be used for the remotely managed systems that do not have a keyboard or a console for
the user to respond.
• PromptWrnErr — System pauses for the user to respond when warnings or errors are detected.
• ContWrn — System continues to boot when warnings are detected, but pauses for the user to
respond when errors are detected.
• ContWrnErr — System continues to boot when warnings or errors are detected.
NOTE: Errors deemed critical to the operation of the system hardware will always halt the
system.
Example
C:\>cctk --WarningsAndErr=disable
WarningsAndErr=disable
154 Options for Dell Command | Congure 4.2