Release Notes

Issue: A warning message is not displayed for BootOrder while enabling and disabling the same device.
Description: Dell Command Configure does not display any warning messages when you try to enable or disable the same bootable
device.
Example: cctk bootorder --bootlisttype=uefi --EnableDevice=hdd.1,hdd.2 --DisableDevice=hdd.1,hdd.2
Resolution: If the current status of the device is enabled, then the same device will be disabled or vice versa.
Issue: If Dell Command | Monitor 10.2 and Dell Command | Configure 4.1 (or any prior versions) are installed in a system, then the Dell
Command | Configure 4.1 (or any prior versions) may not work.
Issue: After the setup password has been set in XPS 9300, Precision 7700, and Precision 7500 series platforms, these platforms does not
allow you to set the system password.
Issue: If you run SCE in windows 7 operating system, Program Compatibility Assistant error is displayed periodically.
Resolution: On Program Compatibility Assistant window, click This program installed correctly and then continue with the further
steps.
10 Known Issues: Command Line Interface