Reference Guide

-I or --Inle
Valid Argument <lename>
Description
Directs the Command Congure utility to take input from an INI le. The utility searches the le for a
Command Congure heading identical to the utility name. An error is returned if the le or section is not
found. If the section is found, each name/value pair is applied to the system. The names must match a
valid option, and the arguments must be in the proper format for the option. If an option is not available
on a system and it is specied in a le, the utility ignores the option. If any errors are found in the format
of the names or values, that option is skipped. The remaining options are applied to the system.
If this option is used with other function command options, they are applied in the order in which they
appear on the command line, overriding any previous commands.
In the INI le, bootorder is displayed as a list of devices with their short forms in the order they are
assigned separated by commas.
For example:
bootorder=legacytype,+pcmcia,+hdd.1,-floppy,+cdrom,-
hdd.2,+nic.1,-hdd.3,+nic.2
A plus (+) symbol with the device name indicates that the device is enabled and a minus (-) symbol
indicates that the device is disabled. You can enable or disable the devices by changing the symbol
displayed with the device short name. These symbols are optional and if not present, the current status
of the device is retained.
NOTE: If the operating system is booted in the Unied Extensible Firmware Interface (UEFI)
mode, then the bootorder type is shown as UEFI type.
Change the boot order by changing the order of the list. You can also enter the device number instead
of the device name.
NOTE
: The bootorder option in the INI le is applied to a system based on its active boot list.
If the INI le is generated from a system with the active boot list set as UEFI, and it is
applied on a system with the active boot list set as Legacy, the boot order is set only on
devices that are available in the system. It is recommended that you apply the INI le on a
system with the same active boot list as of the system from where the INI le is generated.
Example
C:\>cctk -i <c:cctk> /filename.ini
NOTE: For the systems running Ubuntu Core operating system, copy the le at var/
snap/dcc/current, and run dcc.cctk -i /var/snap/dcc/current/<lename>.ini
-l or --logle
Valid Argument
<lename>
Description Logs the command line output to a time-stamped le. The utility either appends the information to an
existing log le or creates a new le. The log le contains the same information as the standard output,
plus timestamp information. Users should use this option instead of redirection for task diagnosis.
Example
C:\>cctk -l <c:cctk> /logfile
22 Dell Command | Congure options