Release Notes
Known Issues: Command Line Interface
Issue: Unable to use Dell Command | Congure after reinstallation/
upgrade
Description: Dell command | Congure may not work after reinstallation/upgrade on Ubuntu Desktop 16.04 because dcdbus module
may not be loaded during reinstallation.
Resolution: Load the module by running the following command:
insmod <filename>
Issue: Windows 7 does not recognize the digital signature validity
Description: If the system is not connected to internet, Windows 7 does not recognize the digital signature validity of Dell Command
| Congure installation le.
Resolution: Connect the system to internet and validate the digital signature.
Issue description: Do not use the inle or outle options in the .ini le.
Issue description: Dell Command | Congure supports only single-byte
characters for asset set operation.
Resolution: If the user has a dierent locale, change the keyboard layout to English before using the asset option.
Issue: TPM-related tokens can be modied independently
Description: Dell Command | Congure does not control the dependencies among the various TPM PPI options. For example, it is
possible to change the TPM PPI ACPI option through Dell Command | Congure even when TPM is not On.
NOTE: There is no negative impact due to this on the BIOS.
Issue: Dependent options are not working as congured in UEFI mode
for Legacy Option ROM and Secure Boot
Description:
• Dell Command | Congure allows enabling Legacy Option ROM when Secure Boot is On.
• Dell Command | Congure allows disabling Legacy Option ROM when Boot mode is Legacy.
• Dell Command | Congure allows enabling Secure Boot when Legacy option ROM is enabled and boot mode is UEFI.
• Dell Command | Congure does not allow enumerating Secure Boot when it is disabled.
NOTE: There is no negative impact due to this on the BIOS. This issue will be addressed in the upcoming BIOS versions.
Issue: Blinkpsu1led and Blinkpsu2led missing in the .ini le or SCE
Description: Blinkpsu1led and Blinkpsu2led will not be present in the .ini le or SCE as they are enable-only tokens and they are
active only for few seconds. These tokens cannot be modied using GUI.
9