Release Notes
Issue: Blinkpsu1led and Blinkpsu2led missing in the .ini le or SCE
Description: Blinkpsu1led and Blinkpsu2led will not be present in the .ini le or SCE as they are enable-only tokens and they are
active only for few seconds. These tokens cannot be modied using GUI.
Issue: advsm option displays the status as Other
Description: If any of the fans is not working, the advsm option displays the status as Other.
Issue: Advance Battery Charge and Peak Shift Charge options display
Disable
Description: Platforms that do not support Advance Battery Charge option, when advbatterychargecfg option is enumerated, the
system displays the option as Disable.
Platforms that do not support Peak Shift Charge option, when peakshiftcfg option is enumerated, the system displays the option
as Disable.
Issue: Temperature probe in Advanced System Management option
displays as Unknown
Description: On some platforms that support Advanced System Management option, temperature probe of all the sensors displays
as Unknown.
NOTE: This issue will be addressed in the upcoming BIOS versions.
Issue: On some of the platforms that support Advanced System
Management option, temperature probe of Memory sensor 2 displays
the current status as Non-Critical instead of Normal.
NOTE: This issue is addressed in the upcoming BIOS versions.
Issue: On some of the platforms that support Advanced System
Management option, when you set non-critical upper threshold values
for cooling device, the CLI indicates that the action failed; however,
setting the same is successful.
Issue: Unable to congure ASM (advsm) BIOS options in .ini le/SCE
Description: While conguring ASM (advsm) option using .ini le, or SCE, Setup password or System password should not be set or
modied.
11