Reference Guide

--serial6

Valid Argument disable, auto

Description Configures the 6th serial port of the system.

--serialcomm

Valid Argument off, on, com1cr, com2cr

Description

Sets the behavior of the serial port communication.

• off — Disables the COM port 1 and COM port 2.

• on — Enables the COM port 1 and COM port 2. These ports are made available for use by the

operating system or applications. BIOS Console Redirection is disabled.

• com1cr — Enables the COM port 1 and COM port 2. These ports are made available for use

by the operating system or applications. BIOS Console Redirection is through COM port 1.

• com2cr — Enables the COM port 1 and COM port 2. These ports are made available for use

by the operating system or applications. BIOS Console Redirection is through COM port 2.

--serrdmimsg

Valid Argument on, off

Description Turns the serr Dmi messages on or off.

--setuppwd

Valid Argument

Description Sets the setup password. An argument is required. The password cannot be displayed. Initially you

can set the password. If you want to remove the password, provide one blank space and the old

password.

Example

NOTE: Password containing special characters must be provided in double inverted

commas (“”).

To set the password:

C:\>cctk --setuppwd=<new-password>

To change the password:

C:\>cctk --setuppwd=<old-password> --valsetuppwd=<new-password>

To remove the password:

C:\>cctk --setuppwd= --valsetuppwd=<old-password>

--sfp

Valid Argument

enable, disable, enablewithpxe

Description

Enables or disables SFP (Small Formfactor Pluggable) device.

• disable — Disables the SFP device.

• enable — Enables the SFP device.

• enablewithpxe — Enables the SFP device with PXE support.