Reference Guide

--fanctrlovrd
Valid Argument enable, disable
Description Controls the speed of the fan.
--fanspeed
Valid Argument auto, high, medium, medium_high, medium_low, low
Description Sets the speed of the fan. If set to auto the system run-time sets the speed of the fan.
--fanspeedctrllevel
Valid Argument Integers ranging from 0 to 100
Description
Configures the fan speed control if the fan speed is set to Auto using fanspeed attribute. 0 sets
the fanspeed to the optimal speed level, and higher percentage provides enhanced cooling.
--fanstealthmode
Valid Argument unchanged, turnoff
Description
Configures the state of the fans depending on the Stealth mode is enabled or disabled.
• unchanged — Retains the current state of the fan.
• turnoff — Turns off the fan if the stealth mode is enabled.
--fastboot
Valid Argument
thorough, minimal, automatic
Description
Enables fast booting.
• thorough — Sets POST to perform complete hardware and configuration testing.
• minimal — Sets POST to perform minimal hardware testing.
• automatic — Allows the BIOS to decide what level of POST test is used.
--faulttolerantmemlogclear
Valid Argument
enable, disable
Description
Enables or disables the Fault Tolerant Memory Log Clear option.
NOTE: Fault Tolerant Memory Log Clear option will be reset to disabled state after log
gets cleared.
• enable — System clears fault tolerant memory log during the next boot.
• disable — Fault Tolerant Memory Log Clear option will be disabled, and no action will be taken
during the next boot.
--firstpowerondate
Valid Argument
Read-only
Description Displays the date on which the system was first turned on.
42