Reference Guide

--satadipm

Valid Argument enable, disable

Description Enables and disables the feature that allows SATA HDDs to initiate link power

management transitions.

Example

C:\>cctk --satadipm=enable

satadipm=enable

--scndidemaster

Valid Argument auto, off

Description Enables or disables secondary parallel IDE master channel.

Example

C:\>cctk --scndidemaster=on

scndidemaster=on

--scndideslave

Valid Argument auto, off

Description Sets the secondary parallel IDE master channel to off or auto.

Example

C:\>cctk --scndideslave=auto

scndideslave=auto

--scsi3

Valid Argument enable, disable

Description Enables or disables the third built-in SCSI controller.

Example

C:\>cctk --scsi3=enable

scsi3=enable

--secureboot

Valid Argument enable

Description

Enables secure boot authentication. If enabled, BIOS should only perform

Secure Boot authentication and boot in UEFI mode without loading

Compatibility Support Module (CSM). BIOS refers to this setting to decide on

the POST behavior.

NOTE: You cannot disable secure boot using the Dell Command |

Configure user interface. One of the methods of disabling secureboot is

from the BIOS setup screen.