Reference Guide

• ac — Charges battery while plugged-in.

• auto — Charges the battery based on a periodic evaluation of battery

usage to deliver the best balance capacity.

• custom — The battery charging starts and stops based on user input. The

start value range should be 50-95 percentage, the stop value range should

be 55-100 percentage, and the difference between the start and stop

values should be greater than or equal to 5.

Example

C:\>cctk --primarybatterycfg=standard

primarybatterycfg=standard

NOTE: The format to set custom option is custom:start value-stop

value. The start value range must be 50–95 percentage and the stop

value range must be 55–100 percentage. The difference between the

start and stop values must be greater than or equal to 5.

--primaryvideodeviceslot

Valid Argument 0, 1-15, 255

Description

Configuring the slot for Primary video display.

• 0 — Sets the onboard video device slot as primary video device slot. .

• 1-15 — Sets the specified slot number as a primary video device slot.

• 255 —Scans PCI buses and uses the first video device slot, found with

video card as a primary video device slot.

NOTE: If a video card is not available in the specified slot number, the

system will scan the PCI buses and uses the first video device slot,

found with video card as a primary video device.

Example

C:\>cctk --primaryvideodeviceslot=0

primaryvideodeviceslot=0

--primidemast

Valid Argument auto, off

Description Enables or disables primary IDE master channel.

Example

C:\>cctk --primidemast=off

primidemast=off

--primideslav

Valid Argument auto, off

Description Enables or disables primary parallel IDE slave channel.

Example

C:\>cctk --primideslav=auto

primideslav=auto