Deployment Guide

Integrating Dell Command | Configure directory structure in WIM file using Microsoft

Windows PE 2.0

Dell Command | Configure provides the cctk_x86_winpe.bat and cctk_x86_64_winpe.bat scripts to

integrate Dell Command | Configure , HAPI, and related Dell drivers into the WIM file. To integrate the

Dell Command | Configure directory structure in a WIM file:

1. Browse to the directory where the script is located.

NOTE: By default, the script for 32-bit system is located at C:\Program Files\Dell\Command

Configure\x86 directory. The script for 64-bit system is located at Command Configure

\x86_64 directory.

2. Run the appropriate script with the WMI file and Dell Command | Configure directory locations

entered as two arguments:

cctk_winpe.bat <path_of wim_file> <path_of_Command

Configure>

. If Dell Command | Configure is installed in the default directory, run the following

script:

• For 32-bit system, cctk_x86_winpe.bat C:\winPE_x86 C:\Progra~1\Dell\Comman~1 .

• For 64-bit system, cctk_x86_64_winpe.bat C:\winPE_x86_64 C:\Progra~2\Dell

\Comman~1 .

NOTE: Make sure that the path mentioned in the command directs to the Command Configure

folder.

The files required to create the bootable ISO image and a WIM file -winpe.wim are created at the

same location.

3. Rename the <path_of_wim_file>\winpe.wim file as boot.wim.

4. Overwrite the <path_of_wim_file>\ISO\sources\boot.wim file with the <path_of_wim_file>

\boot.wim file.

For example, copy C:\winPE_x86\boot.wim C:\winPE_x86\ISO\sources\boot.wim.

5. Create a bootable Windows PE image using Windows AIK.