Reference Guide

--dbs

Valid Argument enable, disable

Description

Enables or disables demand-based power management.

Example

C:\>cctk --dbs=enable

dbs=enable

--deepsleepctrl

Valid Argument s5only, s4ands5, disable

Description Configures the system power mode when the system is in s4 and s5 state. If

set to s5only, the system moves to the lowest-power off mode when in s5

state. If set to s4 and s5 state, the system moves to the lowest-power off

mode when in s4 and s5 states. When the system is in a low-power mode, it

turns off most of the power-consuming circuitry devices, to meet the 1 W

power limit. It disables the Power Management Event (PME), USB power, and

so on.

Example

C:\>cctk --deepsleepctrl=s5only

deepsleepctrl=s5only

--diskettereconfig

Valid Argument anytime, atbootonly

Description Allows the user to hot or warm plug a floppy drive into the system and make it

functional. If set to atbootonly, the drive will be functional after the system is

rebooted. If set to anytime, reboot is not required.

Example

C:\>cctk --diskettereconfig=anytime

diskettereconfig=anytime

--displayclosestate

Valid Argument active, suspend

Description Sets the system to active or suspend state, when the system lid is closed.

• active — system remains in the active state when the system lid is closed.

• suspend — system will be forced to suspend when the system lid is

closed.

Example

C:\>cctk --displayclosestate=active

displayclosestate=active