Reference Guide

-i or --infile

Valid Argument <filename>

Description

Directs the Command Configure utility to take input from an INI file. The

utility searches the file for a Command Configure heading identical to the

utility name. An error is returned if the file or section is not found. If the

section is found, each name/value pair is applied to the system. The names

must match a valid option, and the arguments must be in the proper format

for the option. If an option is not available on a system and it is specified in a

file, the utility ignores the option. If any errors are found in the format of the

names or values, that option is skipped. The remaining options are applied to

the system.

If this option is used with other function command options, they are applied

in the order in which they appear on the command line, overriding any

previous commands.

In the INI file, bootorder is displayed as a list of devices with their short forms

in the order they are assigned separated by commas.

For example:

bootorder=legacytype,+pcmcia,+hdd.1,-floppy,+cdrom,-

hdd.2,+nic.1,-hdd.3,+nic.2

A plus (+) symbol with the device name indicates that the device is enabled

and a minus (-) symbol indicates that the device is disabled. You can enable or

disable the devices by changing the symbol displayed with the device short

name. These symbols are optional and if not present, the current status of the

device is retained.

NOTE: If the operating system is booted in the Unified Extensible

Firmware Interface (UEFI) mode, then the bootorder type is shown as

UEFI type.

Change the boot order by changing the order of the list. You can also enter

the device number instead of the device name.

NOTE: The bootorder option in the INI file is applied to a system based

on its active boot list. If the INI file is generated from a system with the

active boot list set as UEFI, and it is applied on a system with the active

boot list set as Legacy, the boot order is set only on devices that are

available in the system. It is recommended that you apply the INI file on a

system with the same active boot list as of the system from where the INI

file is generated.

Example

C:\>cctk -i <c:cctk>/filename.ini

-l or --logfile

Valid Argument <filename>

Description Logs the command line output to a time-stamped file. The utility either

appends the information to an existing log file or creates a new file. The log

file contains the same information as the standard output, plus timestamp