Release Notes

Issue 6:
Description: Read-only options, such as asset, svctag, and so on, do not report if they
are used along with the -o option.
Issue 7:
Description: At present, Command Configure supports only single byte characters for
asset set operation. If the user has a different locale, change the keyboard layout to
English before using the asset option.
Issue 8:
Description: Following are the known issues on OptiPlex 740:
• Floppy option does not work.
• Usbemu option does not work.
• Asset, minsizeofcontigmem, bioscharacteristics, and completioncode options may not
work.
Issue 9:
Description: On Dell Precision workstation T3500, Command Configure does not
report the correct value of the turbomode option. Though the option is enabled,
Command Configure reports it as disabled.
Issue 10:
Description: On Latitude XT2, for the busratio option you cannot set the argument to
max.
Issue 11:
Description: When you install Command Configure on a Linux system, after installing
the omilcore rpm, the following message is displayed: "To start all installed services
without a reboot, enter the following command: srvadmin-services.sh start".
Resolution: You can ignore the message and can proceed with the installation of other
rpms.