Deployment Guide

Related Links:

• Integrating Command | Configure directory structure to an ISO file using Microsoft Windows PE 3.0

• Integrating Command | Configure directory structure in aWIM file using Microsoft Windows PE 2.0

Integrating Command | Configure directory structure to an ISO file using Microsoft

Windows PE 3.0

Command | Configure provides the cctk_x86_winpe_3.bat and cctk_x86_64_winpe_3.bat scripts to

integrate Command | Configure, HAPI, and related Dell drivers to the ISO image. To integrate the

Command | Configure directory structure to an ISO file:

1. Browse to the directory where the script is located.

NOTE: By default, the script for 32-bit system is located in the Command Configure\x86

directory. The script for 64-bit system is located in the Command Configure\x86_64 directory.

2. If you have installed AIK in a nondefault directory, open the script, set the AIKTOOLS path, and save

the file.

For example, Set AIKTOOLS=C:\WINAIK\Tools.

3. Run the script with the path where you want to create the ISO file and the Command | Configure

installation directory as two arguments.

NOTE: Make sure that the directory specified for the ISO image is not an existing directory.

• For a 32-bit system, run cctk_x86_winpe_3.bat C:\winPE_x86 C:\Progra~1\Dell

\Comman~1.

• For a 64-bit system, run cctk_x86_64_winpe_3.bat C:\winPE_x86_64 C:

\Progra~2\Dell\Comman~1

NOTE: Make sure that the path mentioned in the command directs to the Command Configure

folder.

The ISO image and the WIM file are created in the following folder

• For a 32-bit system; C:\winPE_x86\WIM

• For a 64-bit system; C:\winPE_x86_64\WIM