Users Guide

320 | Understanding Printer Messages
"027-001" - "032-999"
026-728 Check whether the network cable is correctly connected or check the amount of available
memory of the destination device.
026-729 Check whether the network cable is correctly connected or check the amount of available
memory of the destination device.
Use Windows Fax and Scan to scan. If using another application, set the document on the
document glass.
026-730 Check whether the paper guides are correctly positioned in the tray, and then try again.
026-731 Correct the PIN number specified in the PJL command, and try again.
026-732 Correct the print count value specified in the PJL command, and try again.
026-733 Correct the password specified in the PJL command, and try again.
026-734 Wait more than 1 minute after user operation is completed, and then start downloading.
026-739 No measure is required.
Status Code Cause and Remedy
027-442 Change the Self-Assigned Address 1: for IPv6 or the DHCPv6 address on the machine, or
the IP address of IPv6 on the network device, to remove the duplication of addresses.
027-443 Change the Self-Assigned Address 2: for IPv6 on the machine, or the IP address of IPv6 on
the network device, to remove the duplication of addresses.
027-444 Change the Self-Assigned Address 3: for IPv6 on the machine, or the IP address of IPv6 on
the network device, to remove the duplication of addresses.
027-445 The manually configured IPv6 address of the printer is not valid. Change the IPv6 address
of printer.
027-446 Change the Manual Address for IPv6 on the machine, or the IP address of IPv6 on the
network device, to remove the duplication of addresses.
027-447 Change the IPv6 Link-Local Address: for IPv6 on the machine, or the IP address of IPv6 on
the network device, to remove the duplication of addresses.
027-452 IPv4 address duplication on the network. Change the IPv4 address of the printer or the
device on the network.
027-500 Specify the SMTP server name correctly or specify the server by using its IP address.
027-504 An SMTP server error occurred.
Check the SMTP server status. Check if the sender is permitted to access the server.
Contact customer support if this failure is repeated.
027-513 The machine failed to transfer data using SMB of the Scan To service because access to
the SMB server was not permitted.
When the server is Macintosh, a folder with the same name as the specified file name may
exist on the server.
Consult your system administrator for settings.
027-514 Check the following conditions:
• The SMB server is connected to the DNS server.
• The SMB server name is registered on the DNS server.
027-515 • Set the DNS server address.
• Set the target SMB server address using IP address.
Status Code Cause and Remedy