Users Guide

Understanding Printer Messages | 287
003-311
003-318
003-319
003-320
003-321
003-322
003-323
003-324
003-325
003-326
003-327
003-328
003-329
003-330
003-331
003-332
003-333
003-334
003-335
003-336
003-337
003-338
003-339
003-340
003-341
003-342
003-343
003-344
003-345
003-346
An error occurred in the machine.
Turn off the printer, and turn it on again. Contact customer support if this failure is
repeated.
003-700 Too many documents are set in the document feeder after clearing the paper jam.
Check the output, and then replace the documents that have not been copied yet.
003-701 A digital code is embedded in the document to restrict duplication.
003-702 Specify the same Reduce/Enlarge ratio for both sides.
003-703 Place the Calibration Chart properly. Contact customer support if this failure is repeated.
003-704 Try the same operation. Contact customer support if this failure is repeated.
003-705 Copying is started before the machine exits the Power Saver mode and detects the change
for the tray size, when the paper size set in the tray that has been changed during the
Power Saver mode.
Cancel copying, and perform the operation for copying again.
003-750 Check the 2 Sided Book Copying settings, and try the same operation.
003-751 Increase the resolution or scan area.
003-752 Set the resolution to 400 dpi or lower.
003-753 Set the resolution to 200 dpi.
Status Code Cause and Remedy