Users Guide

208 | Print Media Guidelines
• Portrait orientation is preferred, especially when printing bar codes.
• Do not use labels that have exposed adhesive.
• Use full label sheets. Partial sheets may cause labels to peel off during printing,
resulting in a jam.
• Do not use label sheets that have adhesive to the edge of the sheet. It is
recommended that zone coating of the adhesive is done at least 1 mm (0.04 inches)
away from edges. Adhesive material contaminates your printer and could void your
warranty.
WARNING:
• Otherwise a jam occurs in the printer and contaminate your printer and your cartridge with
adhesive. As a result, could void your printer and cartridge warranties.
Print Media Storage Guidelines
For proper print media storage, the following guidelines will help to avoid media feeding
problems and uneven print quality.
• Store print media in an environment where the temperature is approximately 21 °C
(70 °F) and the relative humidity is 40 %.
• Store cartons of print media on a pallet or shelf, rather than directly on the floor.
• If you store individual packages of print media out of the original carton, ensure that
they rest on a flat surface so that the edges do not buckle or curl.
• Do not place anything on top of the print media packages.