Users Guide

Table 7. Dell unit monitors in Dell Client Management Pack
Groups Unit Monitor Name Default Periodic Poll Setting
DCM/OMCI Service Instance Periodic 3600 seconds
(60 minutes)
Memory Group for Dell Client Periodic 3600 seconds
(60 minutes)
Processor Group for Dell Client Periodic 3600 seconds
(60 minutes)
Processor Unit Instance Periodic 3600 seconds
(60 minutes)
Sensors of Dell client systems
• Battery
• Battery Charging status
• Battery Health status
• Current
• Fan
• Intrusion
• Temperature
• Voltage
Periodic 3600 seconds
(60 minutes)
Storage Group for Dell Client Periodic 3600 seconds
(60 minutes)
Disk Unit Instance Periodic 3600 seconds
(60 minutes)
NOTE:
• When chassis door is removed or closed, Dell Command | Monitor or OMCI generates Chassis Intrusion events. For more
information about enabling, disabling, and clearing Chassis Intrusion events, see System Setup (BIOS) in the Owner's Manual of
the Dell client system.
• Monitoring for memory is available at the Group level only.
Customizing unit monitors
You can customize the following parameters of the Dell Client Management Pack unit monitors by using overrides:
• Enabled - Enables you to enable or disable monitors. You can set the Override setting to True or False. The default setting is True.
• Interval in Seconds - The frequency in seconds with which Dell Management Pack polls the Dell device to check the health of a
component. The default is 3600 seconds (60 minutes).
The unit monitors are triggered by a periodic poll that is congured as interval seconds.
14
Dell Client Management Pack operations