Users Guide

Groups Unit Monitor Name Default Periodic Poll Setting

(60 minutes)

Disk Unit Instance Periodic 3600 seconds

(60 minutes)

NOTE

• When chassis door is removed or closed, Dell Command | Monitor or OMCI generates Chassis Intrusion events. For more

information on enabling, disabling, and clearing Chassis Intrusion events, see System Setup (BIOS) in the Owner's Manual

of the Dell client system.

• Monitoring for memory is available at the Group level only.

Customizing unit monitors

You can customize the following parameters of the Dell Client Management Pack unit monitors by using overrides:

• Enabled — Allows you to enable or disable Monitors. You can set the Override setting to True or False. The default setting is

True.

• Interval in Seconds — The frequency in seconds with which the Dell Management Pack polls the Dell device to check the

health of a component. The default is 3600 seconds (60 minutes).

The unit monitors are triggered by a periodic poll configured as interval seconds.

Object discoveries

Table 7. Dell discovery object

Discovery Object Description Groups

Discover Hardware Components for Dell

Client systems

Discovers the disk, memory, sensors, and

processor of your system.

Dell clients

Dell client instance

Hardware components of Dell client

Storage group for Dell client

Disk unit instance

Memory unit instance for Dell client

Processor group for Dell client

Processor unit instance

Sensor group for Dell client

Dell Command | Monitor or OMCI

Services discovery

Discovers the Dell Command | Monitor or

OMCI services.

Dell clients

Dell client instance

Services of Dell client

OMCI service instance

Customizing object discoveries

Using overrides, you can customize the following Dell Client Management Pack discovery parameters:

• Enabled — Allows you to enable or disable discoveries. You can set the Override setting to True or False. The default setting is

True.