Release Notes

This section provides information on the minimum requirements for installing and using the Dell Client Management
Pack version 5.0 for Microsoft System Center Operations Manager and Microsoft System Center Essentials.
Requirements for Managed node
Dell(TM) OpenManage(TM) Client Instrumentation: The recommended version of Dell OpenManage Client Instrumentation
(OMCI) is v8.1.1
NOTE: If the OMCI version available on a client system is earlier than v8.0, then Client system is grouped under the
“UnManaged” group and monitoring is disabled. The Dell Client Management Pack also groups the client systems without
OMCI and Dell Vostro systems under the “UnManaged” group.
Supported Dell Devices
Supported Client Systems: All Dell Optiplex, Precision and Latitude systems that are supported by Dell OpenManage Client
Instrumentation version v8.0 and later are managed using the Dell Client Management Pack v5.0.
Upgrading From Previous Versions
You can upgrade Dell Client Management Pack 4.x to Dell Client Management Pack 5.0.
For information on upgrade to Dell Client Management Pack v5.0, see the "Dell Client Management Pack Version 5.0 For
Microsoft System Center Operations Manager and System Center Essentials Installation Guide".
NOTE: You cannot apply Dell Client Management Pack 5.0 as an upgrade over Dell Management Pack 3.x or any other
versions prior to Dell Management Pack 3.x. Importing the Dell Client Management Pack v5.0 over the Dell Management
Packs v3.x is not a supported configuration.
Un-Installation
For information on uninstalling the Dell Client Management Pack v5.0, see the "Dell Client Management Pack Version 5.0 For
Microsoft System Center Operations Manager and System Center Essentials Installation Guide".
NOTE: The Installation Guide (DellMPv5.0_Client_IG.pdf) is available under the folder where you extracted the Dell Client
Management Pack v5.0.
Open Issues and Resolutions
Issue 1 - DF342472
On few Dell Client platforms, health status does not change to normal after the Dell Client recovers from the Fan Probe
error.
Description
On R5400, T7400 and Optiplex 390 systems, Health status does not change to normal after the Dell Client recovers from Fan
Probe error.
Resolution
Reboot the Dell Client to clear the status of the Fan probe.
Versions Affected
OpsMgr